Immersion Tramp HV er en videosender til FPV-racere, der er meget lette med deres 4gram. Videosenderen kan programmeres og har også pittilstand, der muliggør opsætning med lav transmissionseffekt, mens enhver begivenhed køres. Dette er den version, der understøtter 2-6S LiPo.
Product details in english
Smallest, Lightest in the Business
This is the smallest, lightest, high-power, high-voltage A/V Transmitter in the business, 31 x 20mm, with a slender 17mm waist, weighing only 4 grams!
Even at this size, the traditional ImmersionRC 5V filtered camera power supply is also included. Twin ground cables from the tiny locking connectors ensure that noisy supply currents keep the camera supply clean.
To cap it off, in addition to running directly from a 2s-6s* (HV) LiPo, the TrampHV will happily run from a 5V supply already available in the quad.
Pit Mode
The ImmersionRC TrampHV was the first transmitter to support Pit Mode, which was introduced successfully at the FPVAirShow in France.
Pit mode transmits a tiny amount of power on a pre-defined frequency to allow for quad setup at a race event without disrupting the show.
Pit mode on the TrampHV is a little different than other offerings, being controlled by race directors transparently at drone races. A race director can stay legal by choosing a pit frequency authorized for use at the event, which can be different for events in different regions.
Programmed at the event using the Touch?n?Race wand.
Touch n Race for Race Directors
Touch?n?Race, a patent-pending technology which helps both the casual racer, and race directors alike.Transmitters are placed in Race mode upon arrival at a race event, and remain in that mode until the event is over.Race directors can, without powering up a model, define the frequency and power output of the transmitter, in 5 seconds flat before a race starts.
As soon as the race is over, and the battery disconnected, the TrampHV reverts to it?s race-director defined mode.Massively decreased inter-heat times are possible with this technology, meaning more practice runs, more qualifiers, and races which start and finish on-time (a rarity in the world of drone racing today).
More importantly, the chances of a race being disrupted by an accidental power-up in the pits are eliminated, a dream for race organizers.
PRODUCT SPECIFICATIONSDimensions: L=32mm x W=20mm x H=8mm
Weight: 4g (Tx only, without SMA cable)
Power Output: Programmable, 1mW to > 600mW
Channels: 48 standard, arbitrary using race wand
RF Impedance: 50 ohms
RF Connector: U.FL
AV Connector: JST-GH, 6 pin, locking
TNR Connector: JST-GH, 4 pin, locking
Audio: Mono, Subcarriers on 6.0 and 6.5MHz (cloned)
Modulation: FM, Audio and Video
Pit Frequency: User/Race Organizer Definable
Video Impedance: 75 ohms
Power Requirements: 2s-6s HV Lipo (6s as of March 2017)
Power Consumption: 4W max. @ 600mW, 1.9W @ 200mW
Mere info på engelsk