Produkt information
iFlight SucceX-A F4 AIO med kraftig 4x40A ESC, der kører på 2-6S LiPo. PNP med DJI HD FPV-system med medfølgende kabel. FC bruger USB-C og ikke mikro-USB.
PS! Produktteksten er maskineoversat fra norsk.
Som et kompromis for at være PNP med DJI FPV-systemet har detIkke muligheden for analog OSD. Det kan dog køre med Betaflight OSD i DJI HD FPV (Betaflight OSD pass-through) -systemet.
FC - specifikationer| MCU | 168MHz STM32F405 |
| Vægt | 11.4Gram |
| Gyro | MPU6000 |
| Sort kasse | 8 MB indbygget |
| UART | 5Stk |
| DJI Air Unit-port | 8 Pin (10V/GND/T1/
R1/GND/R2I/T2/5V) |
| Montering af huller | 30,5 Mm @ 4 mm |
| Dimensioner | 43X39mm |
ESC-specifikationer| MCU | STM32F051 |
| Kondensator | 484UF/50V |
| Nuværende sensor | Ja |
| Inn-spænding | 2-6S |
| BlHeli32 | Ja |
| Kompatibilitet | Dshot1200, Proshot, Oneshot, Multishot |
Stillet til rådighedSucceX-A F4 AIO × 1Kondensator 470uF/50V × 1XT60 12AWG-kabelTrådssele (plug & play) til DJI Air Unit × 1M4 til M3 silikonegitter × 4
Product details in english
The SucceX-A F4 AIO(F4+40A) NEXT-GEN flight controller you need for your build. This FC is ready for anything with 5 uarts,4 motor outputs, 8Mb blackbox and a powerful F4 processor to run it all. Designed to work seamlessly with DJI?s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the AIO FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.
Attention: This AIO-Board was specifically designed to run with a DJI Air Unit and takes advantage of DJI?s latest Betaflight OSD pass-through! Because of space limitations we needed to take compromises and removed analog OSD support for this board! If you need analog OSD functionality, please check our latest releases.
Top Features:
DJI Plug-and-Play - No need to solder tiny wires!Gyro Fusion - Zero delay Twin-Gyro filtering!Dual BEC 5V and 10V
Mere info på engelsk
Dele
Find nemt delene
Dette produkt har PartFinder
Partfinder er designet til at gøre det så nemt som muligt at finde den rigtige del til produktet ved hjælp af eksploderede billeder og/eller styklister.
Åbn PartFinder
c
Dele du savner? Klik her!