Fragtfri bestilling over 1.000 kr. Vi fortolder!
HjemDroner til FPV RaceRace dronerFPV Racers Færdigbygget
Udskriv produktark

Happymodel Mobula7 Analog Micro 1S Whoop FRSKY

Producent Happymodel
(1)
Tilhører kategori
FPV Racers Færdigbygget
kr 1.595,-
Kjøp
Overvåge
+
-
Gem til favoritter
3|3|1124
VareID: 58030, Produktnr: 5A10036
Produktinfo
Anbefalet tilbehør
Dele
Tip din ven
Anmeldelser

Produkt information

75 mm Hov
Analogt 5.8G videolink
1 er let
Happymodel Whoop Mobilite7 med Analog 5.8G videoprotokol og FRSKY 2.4G modtager. Leveres BNF og er lavet til 1S batterier. Mobula7 har Runcam Nano3 kamera.

Anbefalet tilbehør

PS! Produktet kan afvige fra videoen.Læs mereKlippet er tilføjet som relevant information til produktet, men er ikke nødvendigvis identisk. Indholdet i en produktvideo, testvideo eller anmeldelse kan afvige fra det produkt, der sælges. Dette kan gælde farver, specifikationer, versionsforskelle, regionale forskelle mv. Det er produktets navn, beskrivelse og billeder, du skal forholde dig til ved køb af varen.

OK
PS! Produktteksten er maskineoversat fra norsk.

Mobula7 er en 75 mm whoop, der vejer kun 24 gram. Kommer med børsteløs motoropsætning og denne version har en analog 5.8G videoprotokol, hvilket betyder at du skal have briller der kan modtage analoge signaler for at se video feedet. Quad'en bruger 1s lipo-batterier, og du har også brug for en kompatibel radio.
Happymodel Mobula7 Analog Micro 1S Whoop FRSKY


Specifikationer
Batterispænding: 1s LiPo/LiHV
Motorafstand: 75 mm
Mål: 99x99x40mm
Vægt: 24 gram
FC/VTX: X12 AIO
Kamera: Runcam Nano3
Motorer: RS0802 KV20000
Propel: Gemfan 1610-2 1,5mm
Ramme: Mobula7 75mm Frame V4
Product details in english
Were glad to launched our new Mobula7 drone , this time the 75mm whoop based on 1s power. Thanks to the new AIO flight controller and the new third-generation RS0802 brushless motor, the new Mobula7 1s Will be the best choice in the whoop season.

The world first 5-IN-1 AIO flight controller with ExpressLRS 2.0 , OPENVTX(up to 400mw), 12A Brushless Blheli_S ESC and Betaflight OSD coming out recently. This is amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight controller.

The new RS0802 motors comes with a new unibell design, use 1.5mm shaft and include PCB bottom plate, high efficiency and much more reliable.

New onboard OpenVTX , max power up to 400mw, provide RCE and PIT mode, it was very useful for race event.

Features:
X12 5-IN-1 AIO flight controller built-in 2.4G ELRS V2.0 and Openvtx
VTX Power up to 400mw
ELRS V2.0 Support
NEW RS0802 KV20000 motors
Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera
Smooth and powerful
Compatible for 1S Lipo/LIHV
Recommend 1S 450mah/550mah/650mah battery(Not include)

Specifications:
Brand Name: Happymodel
Item Name: Mobula7 1S 75mm Micro FPV whoop drone
Wheelbase: 75mm
Size: 99mm*99mm*40mm
Weight: 24g

Motor
Mode: RS0802 KV20000
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:?1.5mm
Motor Dimension(Dia.*Len):?10.5mm*13.5mm
Weight(g):2.0g
No.of Cells(Lipo):1S only
PropellersWeight:0.24g
Material:PC
Pitch:1 inchProps Dia:40mm
Center Thickness:5mm
Center Hole Dia:1.5mm
Flight controller
X12 ELRS V1.0 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280
X12 Frsky V1.0 flight controller built-in SPI Frsky 2.4G receiver Target: CRAZYBEEF4FR
X12 PNP V1.0 flight controller with external TBS CRSF Nano receiver Target: CRAZYBEEF4DX
X12 PNP V1.0 flight controller without onboard receiver Target: CRAZYBEEF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU6000 or ICM20689 or BMI270(SPI connection)
Mount hole size: 25.5mm*25.5mm
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 12A(each) Blheli_S 4in1 ESC
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G OpenVTX 0mw~400mw
Built-in voltage detection
Built-in current sensor
Onboard 4in1 ESCPower supply: 1S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: Z_H_30_REV16_7.HEX
Default protocol: DSHOT300
Support Bluejay firmware
When use Blujay firmware with 48khz, should set startup power to 1100/1200
Onboard SPI ExpressLRS 2.4GHz Receiver
Packet Rate option: 50Hz/150Hz/250Hz/500Hz
ExpressLRS Firmware version: V2.0
RF Frequency: 2.4GHz
Antenna : SMD antenna
Telemetry output Power: <12dBm
Receiver protocol: SPI ExpressLRS
Compatible with ExpressLRS V2.0 TX Module
Couldn?t flash separately ExpressLRS firmware
Onboard Frsky SPI D8/D16 receiver Version
SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 modelChannels: 8ch
No ground interference ( Transmitter and receiver 1 m from the ground): 200meterFailsafe support
Onboard 5.8g OPENVTX
Firmware version: OPENVTX
Smartaudio v2.1
PIT Mode support
RCE Mode support
Channels:48ch
Transmitting Power: 0/RCE/25mw/100mw/400mw
Power supply: DC 5V
Current (5v): <650ma (400mw)
Runcam Nano3
Model: RunCam Nano 3
Image Sensor: 1/3? CMOS
Horizontal Resolution: 800TVL
Lens : 2.1mm(M8) FOV 150°
Signal System: NTSC
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: 0.01Lux@1.2F
D-WDR: Auto
Day/Night: Color
Power:DC 3-5.5V
Current: 110mA@5V 120mA@3.3V
Housing Material: ABS
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm
Mere info på engelsk

Anbefalet tilbehør

1s 500mAh - 95C - Gens Ace Tattu TinyHawk
3|182|173
kr 99,-
1s 500mAh - 80C - Auline EX HV PH2.0 4stk
3|6|1173
kr 249,-
1s 300mAh - 30C - LiHV PH2.0
3|1|173
kr 69,-

Produktanmeldelser

Rolig liten rackare
Bruger har kun givet karakter
26.02.2024 af Peter K.
Frsky accst d8 gick att para ihop med min D8-modul som jag har i min gamla JR3810
Dette hjalp mig
Viser 1 / 1 kommentarer
Giv din feedback

Flere så også med



Størst i Skandinavien
Om os

Lynhurtig levering
Læs mere

Nem udveksling og retur
Gå til udveksling og retur

Kundeanmeldelse prisjagt
Læs vores anmeldelser