Fragtfri bestilling over 1.000 kr. Vi fortolder!
Udskriv produktark

Hobbywing XRotor Micro45A 4in1 ESC&FC F4 G2 Combo

Ikke længere lagerført
Årsagen kan være, at produktet er udgået af leverandøren, erstattet med et nyt produkt, eller har haft for lidt efterspørgsel. Eventuelle spørgsmål kan rettes til kunde service.
Produktinfo
Tip din ven
Anmeldelser

Produkt information

Her får du flight controller og 4in1 ESC i en og samme pakke. Det følger med monteringsdeler for å montere i "stack" samt div kabler og en løs strømkabel med XT60 kontakt.

ESC

Hobbywing XRotor Micro 45A 4in1 BLHeli32 gir deg fire regulatorer i en hvor hver regulator er på 45A, dette sparer vekt og plass, ypperlig til FPV-racers. Takler 3-6s LiPo.
Inngangspenning3-6s LiPo
Størrelse42.6 x 36 x 4mm
Vekt11.5g

Flight Controller

Hobbywing flight controller som støtter Betaflight og Butterflight fastvare. Har OSD brikk, plass for SD-kort og støtter 32KHz looptime.
Product details in english
XRotor Micro 45A 4in1 BLHeli32 6S
  • The 4ini1 ESC not only includes four high-performance 45A BLHeli-32 DShot1200ESCs, two built-in BECs (5V & 10V) for powering FC, LEDs (on VTX) and otherdevices, but also a voltameter module which allows FC to monitor the battery volt& amp in real time.The XRotor Micro 45A 4in1 BLHeli32 6S with a small size(almost the same as a FC) is specially designed for competition FPV(s).
  • The use of high-performance 32-bit ARM MCUs with operating frequency of up to 48MHz,3-in-1 drive ICs, top quality MOSFETs & ceramic capacitors, 3-ounce copper, and 6 layers of PCBsguarantees less heat, higher efficiency and rapider response.
  • The Innovative connecting method via a soft cable (*it works better when pairing withthe XRotor Micro-F4-G2 Flight Control) combined with the shock-absorbing design of mountingholes effectively reduces the impact on high-sensitivity ESC components from outsideshock and provides great shock-absorbing protection to upper devices (i.e. FC).
  • The XRotor Micro 45A 4in1 BLHeli_32 DShot1200, which featuresthe 3rd generation of BLHeli-32 firmware, has great performance& rich functions and supports adjusting parameters or upgradingfirmware via different methods (i.e. via throttle signal wire withusing other development board or a FC flashed with theCleanfight/Betaflight/Butterflight/invaflight firmware).
  • Besides DShot150/300/600 digital throttle signal modes &the regular PWM/Oneshot125/Oneshot42/Multishot throttlesignal modes, the XRotor Micro 45A 4in1 BLHeli_32DShot1200 which features great anti-interference & rapidresponse also supports the latest Dshot1200 superhigh-speed digital throttle signal mode.
  • The ESC firmware uses hardware generated motor pwmfor smooth throttle response and silent operation. Dampedlight does regenerative breaking, causing very fast motorretardation, and it inherently also does active freewheeling.

  • ModelXRotor Micro 45A 4in1 BLHeli32 6S
    SKU30902090
    ApplicationFPVs with 130-300mm Diagonal Wheelbase
    LiPo Power input3S-6S
    Cont.Current45Ax4
    Burst Current60Ax4
    BEC Output5V & 1.5A - 10V & 1.5A
    Input Wires12AWG-130mm* (Red/Black)
    Output WireNo wires but solder tabs
    Connectors InXT60 (w/ Wires Soldered on)
    Connectors Outno
    Weight11.5g
    Size32.7x18.4x6.2mm
    FirmwareHobbywing_XRotor_BLHeli_32 Version
    Throttle CalibrationSupported
    ESC ProgrammingBLHeliSuite32
    DEOSupported
    OneShot ModeSupported
    Multishot ModeSupported
    DShot150/300/600/1200Supported
    TimingSupported
    Motor RotationSupported

    * Note: All the wire length above is the original length, not the length you see from the outside.

    Flight Controller
  • Powerful Hardware for Super Fast Operating Speed
    The STM32F405 MCU, which features powerful computing capacity & super operating speed,combined with the high-sensitivity ICM20602 6-axis motion sensor supports 32KHz PID controller &gyro.

    The built-in OSD chip allows users to adjust or set OSD parameters via theBetaflight/Cleanflight/Butterflight/invaflight software or transmitter easily. The internal TF-cardexpansion slot allows users to insert a SD card to record more flight data.

    Product Name
  • XRotor Micro Flight Controller F4 G2


  • Basic Features
  • Compatible with (Multirotors): Quadcopter
  • Firmware: OMNIBUSF4SD
  • FC Programming: Supported
  • Programming via: Betaflight/Cleanflight-configurator or Others
  • Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc.
  • Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL, and etc.
  • OSD: Built-in
  • Voltage Monitoring: Supported
  • Current Monitoring: Supported
  • External Buzzer: Supported
  • LED Control: Supported
  • BEC: No
  • USB Port: MicroUSB
  • Size: 36*36mm
  • Weight: 6g
  • Mere info på engelsk
    Flere så også med